1111 Lancaster Avenue
P.O. Box 990
Rosemont, PA 19010-0911, USA
phone: 610-527-1300
or 800-727-1022
fax: 610-527-4463
Home Search Catalogs  Diamond Tools   Carbide Tools  Air Motors Accessories Contact Us Site Map

Catalogs C00120 and C00400   < Page 27 >

Solid Micrograin Carbide Drills and Routers
 for use in Fiberglass, Boron, Plastic, Carbon and Other High Abrasive Materials

Tapered Drill Reamer Tapered drill for Graphite and Fiberglass

Excellent for small diameter holes in graphite and fiberglass.  This special drill is recommended for use in most laminated composites other than straight Kevlar.  The drill reamer will produce very clean accurate holes in the most difficult composite materials.  The only requirement is that the work piece be held solidly, to eliminate vibration while being drilled. We recommend that this drill be run at approximately 125-150 SFPM for the best results. 

Dagger Drill Standard diameters available are 5/32", 3/16", #1, #10, and 1/4".

  • Drills 10 times more holes.

  • Drills one shot, class 2 tolerance holes.

  • No backup material required.

  • No secondary ream operation required.

  • Drills holes within .0025 tolerance in a single operation.

  • Maximum heat dispersement while drilling.

  • Can be reground repeatedly without rethinning the point.

  • Can be reconditioned into shorter lengths and smaller diameters.

Combination Drill & C/Sinks, used on Spacematic & Drillmatic Drilling Equipment Parabolic Fluted Drills for Deep-Hole Drilling Special Point for Drilling Kevlar
web site by Solar Systems ss Catalogs Contact Us © 1990-2007 Starlite Industries, Inc.