Excellent for small diameter holes in carbon fiber and fiberglass. This special drill is recommended for use in most laminated composites other than straight Kevlar. The drill reamer will produce very clean accurate holes in the most difficult composite materials. The only requirement is that the work piece be held solidly to eliminate vibration while being drilled. Not necessary to counter sink.

• No backup material required

• No secondary ream operation required

• Drills holes within .0025 tolerance in a single operation

• Maximum heat dispersement while drilling

• Can be re-ground repeatedly without rethinning the point

• Can be reconditioned into shorter lengths and smaller diameters

• Not necessary to center drill beforehand

• OK for acrylics

Special diameters available