1111 Lancaster Avenue P.O. Box 990 Rosemont, PA 19010-0911, USA phone: 610-527-1300 or 800-727-1022 fax: 610-527-4463

Catalog C00400  < Page 1c >

Solid Tungsten Carbide END MILLS

With exclusive superfinished cutting edges, sharper to start with, and they stay sharper . . . longer!

Superfinishing makes these End Mills worth more, do more, last longer.  Cutting edges are tooled to brilliant sharpness and, when operating, this extra-setp superfinishing minimizes chip build-up . . .  enables them to run at the same speed as H.S. Steel on older equipment with, naturally, 10 to 20 times the life of H.S. Steel between regrinds.  On newer equipment these End Mills may be run up to 4 times indicated speed for H.S. Steel.

Modifications from Standards Available

The following modifications from standard End Mills shown on the next three pages are available:

1. Straight Flutes.	5. Positive Rake.
2. Left-Hand Spiral Flutes.	6. Negative Rake.
3. Slow Spiral.	7. Different number of flutes.
4. Fast Spiral (45º).	8. Special Flute Length.

Special End Mills ordered involving any combination of the above modifications available.  For modifications, write or Email us for quotation.